Lift the fuse out with a pair of needle-nose pliers to check the small metal wire inside of it. Resistive load.When you remove the factory speakers and instead feed the radio output to an aftermarket amplifier or sound processor, the radio has no load and the output becomes unbalanced. A special resistive load needs to go between the radio and the next device . About half the time when I turn on the stereo the left channel speaker doesn’t work. If I turn the balance all the way to the left on the receiver, and increase the volume sharply, the speaker comes on.
Mike, Usually noise induced when the engine runs is caused by loose power or ground connections. In your case it sounds like the antenna’s power or ground connection is loose, or the adapter isn’t the correct one, or the antenna is faulty. I installed an aftermarket Kenwood radio with a built in amp and have a very stubborn issue which I can’t solve for years since I installed it.
If there’s a problem in the wiring, the radio will definitely not work. Michael Evanchuk is a San Francisco-based sound engineer with 20 years’ experience installing, troubleshooting, and repairing commercial, automotive, and household sound equipment. Evanchuk owns an auto stereo center, where he offers highly competitive car audio installation and repair services. He has written dozens of articles on different sound engineering topics, all of which have been published in leading journals, blogs, and websites. He enjoys swimming and boat riding during his leisure time.
Tapped off of them are the two rear pillar speakers and the two dash speakers. Just in case they changed that for ’98, you can verify that by removing one of the speakers with an amp and measuring the voltage on the power and ground wires. The red / dark green must have 12 volts when the ignition switch and radio are turned on.
Radio On Avrs
Additionaly being Android tv am not able to add it to my Google home to cast the contents directly. I dont have an option to see the software version of the tv too and none of the customer care people dont know. The user interface for the same is both complicated, and hardly get proper sound through smart tv. In case of hardware issues their service is better, but in case of software they have to upgrade themselves to the market. A crisp, vivid picture isn’t worth much if the colors you’re viewing are off.
If not, you probably have a dead outlet or a circuit breaker has tripped. Before assuming that the outlet itself is dead, plug an appliance directly into the outlet, such as a CD player.
It was part of the switched power circuit that is there to keep from running down the download battery when everything should be off. These Alpine radios that Honda put in have just crappy solder in them. So the fix is to strip them down to the main board, clean off the little bit of conformal coating they have, and resolder everything.